Near Intersection of I-35 & I-90 Southern Mn. | This agrees with my thinking and what others have stated.
Again the idea is to be able to map split varieties with an Ag Leader display when only one hydraulic drive is being used. To use split planter, the multi-product unlock must be present. Then a person can create a configuration for a two drive system. This would allow split planter to be used.
The problem is the system will complain because it would feel that Channel 2 is not responding since it is not receiving a rate from the shaft 2 sensor (there isn't one).
The solution is to provide a signal for Channel 2. Splitting the signal output on Pin C is a simple way to do this. Instead of the signal just getting to Channel 1 where it needs to be, it also goes to Channel 2 to keep it from complaining.
You do need to enter the same target population for both "sides". That way if the system is correctly adjusting the rate for Channel 1, Channel 2 should not complain. If the system cannot adjust the rate for Channel 1, both Channel 1 and Channel 2 will complain.
Edited by tedbear 1/8/2025 11:09
|
how to trick a kinze hyd drive into being able to split planter hybrids
