|
Holly Hill, SC | I have a JD 694 on a Case 5088 and a JD 606C on a Case 6150. For the 606C (easier than the 694) you have to grind, plasma cut and torch the upper width of the hole larger, make some heavy guide blocks at the corners, make triangle shims at lower corners, make or buy a wedge block for the bottom, buy new hydraulic quick connect and make a mount, change wiring connection end and probably move some electrical pins (only got the lights and turn signals to work since I do not need row height sensors), make or buy latch pin bracket, make or buy handle latch holder, also weld a round rod on the top of the tool bar to help hold against the upper hooks on the case feeder house. and change the pto shaft end to be compatible with the combine (might work as is since Case finally started using 21 spline on the feeder house). Can take pictures if you are interested. | |
|
John deere 612C on a case ih combine?
