AgTalk Home
AgTalk Home
Search Forums | Classifieds | Skins | Language
You are logged in as a guest. ( logon | register )

Deere Boundaries to Viper 4+ Sprayer
View previous thread :: View next thread
   Forums List -> Precision TalkMessage format
 
kgbarnett22
Posted 12/17/2024 14:54 (#11013913 - in reply to #11013295)
Subject: RE: Deere Boundaries to Viper 4+ Sprayer


NE Indiana
I'm not sure how Digifarm gets their signal into the deere receivers, but I assume it has something to do with that. Deere 3000 and 6000 receivers will only accept the Deere rtk signal so digifarm must be converting that somehow and that's probably what messes up the position. A deere 7000 and 7500 will accept RTCM rtk signal so it would match up with any other brand rtk rover. I use MyWay rtk. When we switch to a Hagie sprayer last year I got it with an rtk 3000 receiver. When I hooked the myway to it I could only connect to base stations that they had a deere receiver at. This worked ok but the closest station they had with a deere receiver was around 25-30 miles away. I switched to a 7500 rtk receiver and can now connect to a base station 5 miles away that outputs RTCM. Probably would be a good idea to contact digifarm and see what they recommend.

It is strange that your boundaries made with the Deere receiver are good with the Case system though because they should be similar to the Raven. Have you made absolute certain your measurements are right on the sprayer? Or that the sprayer is actually connecting to the RTK and not using a lesser signal.

Edited by kgbarnett22 12/17/2024 14:58
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete cookies)