|
| Hi. I have a 6320 with Trimble fmx Rtk that is giving me this error code 42 - low voltage.
I replaced the hydraulic sensor transducer, then the cable form it to the nav 2 harness without much luck
I have the 6xx0 _6x30 selected.
Voltage on the diagnostic page is around 0.3 to 4.0 on the steering sensor but drops below 0.3 often.
I bench tested the sensor and when you power them with 5 volts they signal back 0.5.
Anyone had the same problem? Any possible solutions?
Thanks
Edited by tgaggero 12/16/2024 20:17
 (IMG_7289 (full).jpeg)
Attachments
----------------
 IMG_7289 (full).jpeg (101KB - 1 downloads)
| |
|
Trimble Fmx error code 42- override sensor low voltage.
