AgTalk Home
AgTalk Home
Search Forums | Classifieds | Skins | Language
You are logged in as a guest. ( logon | register )

ISOBUS problems
View previous thread :: View next thread
   Forums List -> Precision TalkMessage format
 
c_mayer
Posted 12/14/2024 07:28 (#11008720 - in reply to #11008036)
Subject: RE: ISOBUS problems


Jeffersonville, OH
2T Farms - 12/13/2024 16:42

Currently have a 2015 CASE 240 and a 2015 JD DB44 planter. I am running a Reinhardt Green Fit system on the tractor (works fine) with a 2630 monitor as my guidance.

Problem: The planter will not populate up on the ISOBUS (Case 240) which has the 2630 monitor. However, when I plug the same planter into a JD tractor with a 2630 monitor, the planter populates up fine. I have swapped ISO plugs around on the Case tractor and still have the same problem. CAN Hi and CAN Low voltage are where they need to be.

Any suggestions on which direction to look?


BigAl4102 above has it right, but a call to Reichardt would get it sorted out very quickly. Their service is top notch in my book, sold probably 15 systems of theirs for AGCO and Versatile tractors and they are always great when I need something, or just clarification on an issue. AGCO likes to change pins or locations of harnesses, so sometimes the directions aren't right, or I need to tell them about something we found. Always great.

Deere is not ISO until 2017 I believe, so the 2630 HAS to be on the same CAN as the planter...I'm sure Reichardt has seen that before.

You also may have a fuse blown and it's not powering up one side of the ISO connector on the Magnum, so it's not populating on the 2630

Chris
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete cookies)