|
Bremen, KS | Specifically, how did you route the CAN Bus cable into the grain tank to connect to the flow sensor?
I have the large clean grain elevator belt shields off as I needed to replace the upper sprocket and bearings. Looking at things, I am considering running the cable along the elevator chain adjustment rod which isn't used for adjustment any longer and then over toward the flow sensor. In doing so I would cut a hole in the larger of the two shields to pass the cable through and seal it up with a provided grommet and silicone. I think this would be better than poking a hole through the bottom of the grain tank.
Edited by Nate B. 9/12/2024 12:44
| |
|
Question for those who've installed an Ag Leader yield Monitor on a JD 9500
